Physics II Lab w answers_Part_23

Physics II Lab w answers_Part_23 - Fig 6 4. Let the DC...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
57 Fig 6 4. Let the DC power supply to solenoid be switched off to begin with. Switch on the power supply to the CRT. Select the AC supply in the ‘Off’ position .Use the intensity & the focus controls to obtain a point –like spot at the center of the screen. Next select the AC supply in the ‘X’ position and adjust the voltage using the control to get a line on the screen about 1.5 cm long .Using a voltmeter across the terminals of the accelerating voltage supply adjust the control to set the voltage V a =250 V. 5. Switch on the DC power supply to the solenoid .As you increase the voltage the line on the screen shrinks and also rotates. Increase the voltage so that the line shrinks to a point on the screen. This is the focusing effect. If the does not completely shrink to a point in the voltage range available adjust the rheostat position till this is possible. Note down the current I 1 through the solenoid at this point. 6.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 11/26/2011 for the course PHY 2053 taught by Professor Lind during the Fall '09 term at FSU.

Page1 / 2

Physics II Lab w answers_Part_23 - Fig 6 4. Let the DC...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online