17_ch 10 Mechanical Design budynas_SM_ch10

# 17_ch 10 Mechanical - budynas_SM_ch10.qxd 17:23 FIRST PAGES Page 277 277 Chapter 10 The shaded areas depict conditions outside the recommended

This preview shows page 1. Sign up to view the full content.

Chapter 10 277 The shaded areas depict conditions outside the recommended design conditions. Thus, one spring is satisfactory–A313, as wound, unpeened, squared and ground, d = 0 . 0915 in, OD = 0 . 879 + 0 . 092 = 0 . 971 in, N t = 15 . 59 turns 10-24 The steps are the same as in Prob. 10-23 except that the Gerber-Zimmerli criterion is replaced with Goodman-Zimmerli: S se = S sa 1 ( S sm / S su ) The problem then proceeds as in Prob. 10-23. The results for the wire sizes are shown below (see solution to Prob. 10-23 for additional details). Iteration of d for the ﬁrst trial d 1 d 2 d 3 d 4 d 1 d 2 d 3 d 4 d 0.080 0.0915 0.1055 0.1205 d 0.080 0.0915 0.1055 0.1205 m 0.146 0.146 0.263 0.263 K B 1.151 1.108 1.078 1.058 A 169.000 169.000 128.000 128.000 τ a 29.008 29.040 29.090 29.127 S ut 244.363 239.618 231.257 223.311 n f 1.500 1.500 1.500 1.500 S su 163.723 160.544 154.942 149.618 N a 14.191 6.456 2.899 1.404 S sy 85.527 83.866 80.940 78.159 N t 16.191 8.456 4.899 3.404 S se 52.706 53.239
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 12/13/2011 for the course EML 3013 taught by Professor Shingley during the Fall '11 term at UNF.

Ask a homework question - tutors are online