3-Assignment3

# 3-Assignment3 - ELECTRICAL ENGINEERING DEPARTMENT...

This preview shows pages 1–2. Sign up to view the full content.

ELECTRICAL ENGINEERING DEPARTMENT CALIFORNIA POLYTECHNIC STATE UNIVERSITY EE 255 Assignment #3 Problem 1: The magnetic core shown in the figure has the following parameters: . 60 , 5000 turns, 1000 N , cm 25 A , cm 10 r 2 c Hz andf l c = = = = = μ For a current of A ) cos( 5 ) ( t t i ϖ = , determine: (a) Flux in the core, (b) Flux linkage, (c) Inductance [L=157H] (d) Induced voltage rms E .[ KV ° = 90 296 E rms ] ) ( t i N - + ) ( t e Problem 2: A 3 KVA, 480:240-V, 60-Hz single-phase ideal transformer is supplying a load impedance of 15 + j20 at 240 V. Determine the load current, source current and the impedance seen by the source. [ + = 80 60 Z L j ] P roblem 3: A 2200/220-V, 60-Hz, single-phase ideal transformer is supplying a load through a line impedance of 9 + j12 . The load is a heating load with a resistance of 180 . The line is in series with the load and is connected to the 220 V side. Determine the power supplied to the load and the power supplied by the source. What is the

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 12/19/2011 for the course EE 295 taught by Professor Alishaban during the Fall '11 term at Cal Poly.

### Page1 / 2

3-Assignment3 - ELECTRICAL ENGINEERING DEPARTMENT...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online