346_Mechanics SolutionInstructors_Sol.Manual-Mechanics_Materials_7e.book_Gere_light.1

346_Mechanics SolutionInstructors_Sol.Manual-Mechanics_Materials_7e.book_Gere_light.1

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Sec_3.9-3.11.qxd 340 9/27/08 1:14 PM Page 340 CHAPTER 3 Torsion Solution 3.11-4 Stepped shaft in torsion P 600 kW n D1 400 rpm Use the dashed line for a full quarter-circular fillet. 100 mm allow R L 0.075 D1 100 MPa R Full quarter-circular fillet 7.5 mm POWER P 2pnT ( Eq. 3-42 of Section 3.7) 60 P watts n T 60P 2pn 60(600 * 103 W) 2p(400 rpm) rpm 0.075 (100 mm) 0.075 D1 T Newton meters 14,320 N # m D2 D1 D2 115 mm 2R 100 mm 2(7.5 mm) 115 mm ; This value of D2 is a lower limit ; (If D2 is less than 115 mm, R/D1 is smaller, K is larger, and max is larger, which means that the allowable stress is exceeded.) USE FIG. 3-48 FOR THE STRESS-CONCENTRATION FACTOR tmax Kt nom K Ka 16T b tmax(pD3) 1 16T pD3 1 (100 MPa)(p)(100 mm)3 16(14,320 N # m) 1.37 Problem 3.11-5 A stepped shaft (see figure) has diameter D2 stress is 15,000 psi and the load T 4800 lb-in. What is the smallest permissible diameter D1? 1.5 in. and a full quarter-circular fillet. The allowable shear ...
View Full Document

This note was uploaded on 12/22/2011 for the course MEEG 310 taught by Professor Staff during the Fall '11 term at University of Delaware.

Ask a homework question - tutors are online