This preview shows pages 1–2. Sign up to view the full content.
This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: . The actual motor has slightly different dimensions than shown below, but the basic foot-print is the same, so these should get you going. The electrical leads will come directly out from the bottom of the motor. MAE 184 Spring 08 Page2 of 2 Clock Project Notes Shafts and Bushings: We have some 1/8 SS (Stainless Steel) shaft available that can be cut to any desired length. We will also have some bronze bushings that can be used for bearing surfaces for the shafts. The Part number is FBB-02/04; you can use the guide below to create the bushing part model. http://www.smallparts.com/products/descriptions/tbb-sbb-fbb.cfm...
View Full Document
This note was uploaded on 12/21/2011 for the course MAE 184 taught by Professor Staff during the Fall '08 term at Syracuse.
- Fall '08