hw6.sol.Fall.2010x - 1 ME 452: Machine Design II Solution...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: 1 ME 452: Machine Design II Solution to Homework Set 6 The steel arm shown below is keyed to a 2.0 diameter shaft which does not rotate. The load applied to the end of the arm, P, varies with time as shown. For the square key, which connects the arm to the shaft, the following is known: Length = 3.0 inches (into the page) S e = 25,000 psi (fully corrected endurance limit) S ut = 70,000 psi (ultimate strength) S y = 45,000 psi (yield strength) a. Calculate the midrange and alternating nominal shear stresses in the key, in terms of the unknown dimension, h (inches). b. Calculate the dimension, h, inches, for the key such that the infinite-life fatigue factor of safety for the shear stress in the key using the Goodman failure criteria is 2.0. c. Calculate the infinite-life fatigue factor of safety for the normal stress on the side of the key (crush) using the Goodman failure criteria for the value of h calculated above....
View Full Document

This document was uploaded on 12/28/2011.

Page1 / 4

hw6.sol.Fall.2010x - 1 ME 452: Machine Design II Solution...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online