Lab1 - In addition to its ability to read analog voltages...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
In addition to its ability to read analog voltages from the LabJack , Matlab can also set the output voltage of digital ports. We will use this capability to control the rotary motion of optical components to test Snell’s Law of Refraction. In addition to the laser and photodiode from Lab 0, we will use: A stepper motor and controller which converts logic pulses from the LabJack into discrete rotary motion. In other words, depending on the stepper controller settings, a single logic pulse from the LabJack will cause the motor shaft to turn 1/400, 1/1000, 1/2000, or 1/10 4 rotation. A translation stage which converts rotary motion into linear motion with a 0.25mm-pitch lead screw. Place the motor between the laser and photodetector (mounted on the translation stage) so that the rotor is vertical and the sample stage is installed. Close the aperture until the voltage signal is within the measurement range when you align the laser into the detector. You can send pulses to the motor controller from the LabJack FIO1 output port and
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 12/29/2011 for the course PHYSICS 375 taught by Professor Eno during the Spring '11 term at Maryland.

Page1 / 2

Lab1 - In addition to its ability to read analog voltages...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online