pspice_transient_fourier_settings

Pspice_transient_fou - PSpice Hints for Project PSpice Transient and Fourier Analysis Settings In the schematic window Analysis-> Setup-> Transient

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
PSpice Hints for Project PSpice Transient and Fourier Analysis Settings In the schematic window: Analysis -> Setup -> Transient Print Step = 1us This is the time between points in the output data file if you print the waveform out. Final Time = 10ms I use 100 cycles to let initial transients die out and get an accurate frequency spectrum Step Ceiling = 1us This forces the maximum simulation time step to this value. A good number to use is 100points per cycle. With a 10kHz input, this is a print step of 1us. Center Frequency = 10e3 The fundamental frequency used in the Fourier Analysis. For a linear amplifier, set this to your input source (10kHz). Number of harmonics = 5 The number of harmonics used in the Fourier Analysis.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 2
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 01/01/2012 for the course ECEN 325 taught by Professor Silva during the Spring '08 term at Texas A&M.

Page1 / 2

Pspice_transient_fou - PSpice Hints for Project PSpice Transient and Fourier Analysis Settings In the schematic window Analysis-> Setup-> Transient

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online