Homework 4 - 1332 - Fall 11

Homework 4 1332- - 2 Create the part shown below Dimensions shown are in millimeters Turn in an isometric view of the part like the one shown below

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
ENGR 1332 – Fall 2011 Homework 4 1. Create the part shown in the figure below. For scale, the long dimension at the bottom of the part is 100mm, and the shorter dimension at the bottom of the part is 50mm. The 4 holes are 10mm diameter. Turn in an isometric view of the part, like the one shown below, and a printout of all sketches used to create the features in the part.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 2
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: 2. Create the part shown below. Dimensions shown are in millimeters. Turn in an isometric view of the part, like the one shown below, and a printout of all sketches used to create the features in the part. Hint: Use a circular pattern to create the 6 holes around the pulley....
View Full Document

This note was uploaded on 01/10/2012 for the course ENGR 1332 taught by Professor Nazemetz during the Fall '08 term at Oklahoma State.

Page1 / 2

Homework 4 1332- - 2 Create the part shown below Dimensions shown are in millimeters Turn in an isometric view of the part like the one shown below

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online