A6 - ExCiTe Engineering Technology Assignment#6 Ammeter...

This preview shows pages 1–3. Sign up to view the full content.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: ExCiTe Engineering Technology Assignment #6 Ammeter, Power, Equivalent Resistance • Show ALL OF YOUR WORK and attach your simulation outputs to your submission • Follow the homework format described in the syllabus • You may NOT use the POWER MARKERS in PSPICE for this assignment Individual Assignment (problems 1 through 4) 1) Perform a DC (bias-point) analysis on the circuit shown in Figure 1 using Orcad Lite and determine the conventional current flowing into R1 (I R1 ) by: (a) Using the bias current display “I.” (b) Using the bias voltage display to find V R1 and Ohm’s Law to calculate I R1 . (c) Placing a 1-ohm sense resistor in series with R1 (see Figure 2), measuring the voltage across it and using Ohm’s law. R1 560 D1 D1N4002 IR1 VR1- + V1 5V Figure 1 – Circuit Schematic for Problem 1 D1 D1N4002 IR1 VR1- + Rsense 1 R1 560 V1 5V Figure 2 - Circuit Schematic with Rsense ExCiTe Engineering Technology Assignment #6 Ammeter, Power, Equivalent Resistance 2) Using the results from problem 1, answer the following: (a) Is there a difference in the three current measurements (I R1a , I R1b , I R1c )?...
View Full Document

This note was uploaded on 01/10/2012 for the course ENG 0618-213 taught by Professor Hurny during the Fall '07 term at RIT.

Page1 / 5

A6 - ExCiTe Engineering Technology Assignment#6 Ammeter...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online