This preview shows pages 1–2. Sign up to view the full content.
This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: (800) 255-8886 or (518) 237-3330 www.ge.com/silicones/sealants 2.2 FABRICATION A. General 1. 3000 psi concrete minimum 2. Chamfered edges. 3. Free from pits and rock pockets. B. Parking Bumpers 1. Cast openings for pins. 2. Cast in two bars, No. 3 minimum, full length of bumper less coverage requirements. 3. Pins - Galvanized steel pipe 3 / 4 inch diameter, 24 inches long. C. Splash Blocks 1. 16 inches wide by 24 inches long by 3 inches high. 2. Formed water trough. 3. Cast in reinforcing mesh. Project Number 2 Section 03480- Heritage May 2003 Precast Concrete Specialties PART 3 EXECUTION 3.1 INSTALLATION A. Parking Bumpers 1. Install level with paving and aligned with sidewalks. 2. Recess anchoring pins 1 / 2 inch below top of bumper. Calk hole to top of bumper. B. Splash Blocks - Set level in planting areas and centered under each downspout. END OF SECTION...
View Full Document
This note was uploaded on 01/11/2012 for the course CM 105 taught by Professor Burr,k during the Winter '08 term at BYU.
- Winter '08