This preview shows pages 1–2. Sign up to view the full content.
This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: B. Treads - One inch round rungs. C. Mounting Brackets - Drilled angles. 2.3 FABRICATION A. Fabricate ladders to comply with requirements of ANSI A 14.3. B. Weld joints. Grind joints to be smooth to the touch and finished to match adjoining surfaces. C. Space treads 12 inches on centers. D. Fabricate mounting brackets of drilled angles. E. Prime ladders. PART 3 EXECUTION 3.1 INSTALLATION A. Support ladder with welded steel brackets located at top and bottom, and equally spaced but no more than 60 inches on center between top and bottom where ladder is installed against a wall. Size brackets to support design loads specified in ANSI A 14.3. END OF SECTION...
View Full Document
This note was uploaded on 01/11/2012 for the course CM 105 taught by Professor Burr,k during the Winter '08 term at BYU.
- Winter '08