This preview shows pages 1–2. Sign up to view the full content.
This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: Notify Architect of unsuitable conditions in writing. Do not install board over unsuitable conditions. 3.2 PREPARATION A. Separate boards and allow them to be exposed to Project environmental conditions for 24 hours minimum. 3.3 INSTALLATION A. Fastening 1. Do not apply screws closer than 3 / 8 inch to ends or edges. Space screws not over 10 inches on center in field and 6 inches at ends and edges. 2. Adjust power screw-driver to set heads in 1 / 32 inch dimple. 3. Drive screws with shank perpendicular to face of board. B. Single Layer Application 1. Edge joints to be parallel to and occur over framing members. 2. Leave gap between boards as recommended by Manufacturer. 3.3 PROTECTION A. Protect sound deadening board from moisture until completion of Project. . END OF SECTION...
View Full Document
This note was uploaded on 01/11/2012 for the course CM 105 taught by Professor Burr,k during the Winter '08 term at BYU.
- Winter '08