This preview shows pages 1–3. Sign up to view the full content.
This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: Project Number 1 Section 15915 Project Name Project Date Electric And Electronic Control SECTION 15915 ELECTRIC AND ELECTRONIC CONTROL PART 1 GENERAL 1.1 SUMMARY A. Includes But Not Limited To 1. Furnish and install automatic temperature control system as described in Contract Documents. 2. Furnish and install conductors and make connections to control devices and equipment. 3. Assist in air test and balance procedure. B. Related Sections 1. Section 13352- Air test and balance 2. Section 15051- General Mechanical Requirements 3. Section 15820- Furnishing and installing of temperature control dampers 4. Section 15826- Furnishing and installing damper actuator for Type 5 fire / smoke dampers 5. Division 16 - a. Furnishing and installing of raceway, conduit, and junction boxes, including pull wires, for temperature control system except as noted above. b. Power wiring to magnetic starters, disconnect switches, and motors. c. Motor starters and disconnect switches, unless integral with packaged equipment. 1.2 SYSTEM DESCRIPTION A. Performance Criteria - Install line and low voltage electrical wiring, raceway, conduit, and boxes in accordance with Division 16 of these Specifications. 1.3 SUBMITTALS A. Quality Assurance / Control - Provide written confirmation of certifications required under Article 1.4 - Quality Assurance. B. Closeout 1. Project Record Documents - Provide two copies of record ATC diagrams 1.4 QUALITY ASSURANCE A. Qualifications 1. ATC system providers / installers shall have following certifications and training before submitting quote - a. From Honeywell Inc - 1) Comfort Control Energy Spet (CCES) 2) Automation Control Spet (ACS) 3) Automation Control Integrator (ACI) b. From Approved Supplier - Be trained and certified in Owner specific communicating T7300 installation requirements by approved equipment supplier listed under paragraph 2.2,J and used by ATC system provider / installer. PART 2 PRODUCTS 2.1 GENERAL A. System controls shall be single manufacturer's products. 2.2 COMPONENTS Project Number 2 Section 15915 Project Name Project Date Electric And Electronic Control A. Room Thermostats 1. Programmable Thermostat Kit - a. Y7300M2028, Communicating Subbase 3H 3C b. Components Included in Kit - 1) Thermostat - a) Low voltage type provided with automatic change over feature for both heating and cooling stages, seven day program with two starts and stops per day, and provisions for damper operators. b) Approved Product- (1) Honeywell T7300F2010 2) Discharge Air Sensor - a) Approved Product- (1) Honeywell C7046C1000 3) Communicating Subbase - a) Approved Product- (1) Q7300H2029 B. Remote Room Sensor 1. Approved Products- a. With Three Push Buttons, OVERRIDE, WARMER, COOLER - Honeywell T7147A2018 b. Dual Element With Three Push Buttons, OVERRIDE, WARMER, COOLER - Honeywell T7147G2023 c. Plain face, without buttons - Honeywell T7047C2007 2. Switch SW-1 - a. SPDT sub-miniature switch....
View Full Document
This note was uploaded on 01/11/2012 for the course CM 105 taught by Professor Burr,k during the Winter '08 term at BYU.
- Winter '08