Homework5

# Homework5 - IE 370 Homework 5 Due Oct 31st. Name and ID 1....

This preview shows pages 1–2. Sign up to view the full content.

IE 370 Homework 5 Due Oct 31st. Name and ID 1. Why friction is such an important parameter in metal working operations? 2. Indicate 5 advantages of cold working relative to warm and hot working. 3. What are the advantages and disadvantages of hot working? 4. A tensile test is carried out to determine the strength constant C and strain-rate sensitivity exponent m for a certain metal at 1000F. At a strain rate = 10/sec, the stress is measured at 23,000 lb/in ; and at a strain rate = 300/sec, the stress = 45,000 lb/in . (a) Determine C and m. (b) If the temperature were 900F, what changes would you expect in the values of C and m (simply indicate increase or decrease)? 5. Copper is being reduced from a hot-rolled 3/8 in diameter rod to a final diameter of 0.1 in. by wire drawing through a series of dies. The final write should have a yield strength in excess of 50,000psi and an elongation greater than 10%. Use the figure below to determine the range of suitable amount of final cold work. (hint:

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 01/22/2012 for the course IE 370 taught by Professor Chunghorng,r during the Spring '08 term at Purdue.

### Page1 / 2

Homework5 - IE 370 Homework 5 Due Oct 31st. Name and ID 1....

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online