Back-Probing Terminals — WSU

Back-Probing Terminals — WSU - Back-Probing...

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
Back-Probing Terminals Back-probing terminals is done when live circuit measurements are required. It is always better to back-probe a terminal than it is to pierce a wire's insulation to obtain a measurement. To back-probe a terminal: Remove the Terminal Position Assurance clip (if equipped) Insert a long straight pin, T-pin, or meter probe into the back to the connector to contact the desired terminal. If multiple pins are to be used in the same connector, make sure the pins cannot touch
Background image of page 1
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 02/06/2012 for the course AUSV 1320 taught by Professor Johnkelly during the Winter '12 term at Weber.

Ask a homework question - tutors are online