HWK 9-1 - PGE 430 HWK 9 Due in lecture Nov. 13th. (1) Using...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
PGE 430 HWK 9 Due in lecture Nov. 13 th . (1) Using the charts on the last page, please determine the mud flow rate, the bit nozzle diameters, the total WOB, and the surface pump pressure to balance the motor bearings if: The 8”, P150 motor must turn 200 rpm. The WOB required to make the bit drill is 10,000 lbs (in addition to the WOB to balance the pressure thrust through the motor). The bit has five nozzles. Recall that the required pump pressure is the summation of the friction pressure in the pipe and annulus, the pressure drop through the motor, and the pressure drop through the bit. You may use your hydraulics spread sheet to make the calculations. The drill string is as follows: Drill pipe = 4.5” x 3.6” ID; Drill Collars = 6.25” x 2.5” x 300’ in length; Hole Depth = 8,000’; Bit diameter = 9 7/8”; Mud weight = 11 ppg, viscosity = 30 cp
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 2
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 4
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 4

HWK 9-1 - PGE 430 HWK 9 Due in lecture Nov. 13th. (1) Using...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online