Lab #16

Lab #16 - JaclynAucoin Summer2003Sec1 Lab#16

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
Jaclyn Aucoin Summer 2003-Sec 1 Lab #16 Design and Characterization of Emitter-Coupled Transistor  Pairs 6/30/2003 Lab Partner: Steve Smith
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
1) Design and construct the circuit in figure 1: Choose values of the resistors and supply voltages so that with no input to the circuit each collector is at approximately half the positive supply voltage. What are the values of the resistors and supply voltages? Rc1=Rc2=4.7kΩ, Rb1=Rb2=10kΩ, Re=4.7kΩ, V+=10V, V-=-10V. Measure the dc voltages at points A, B, and C. A=-0.7276V, B=4.763V, C=6.142V. Apply a small sinusoidal signal to input 1 but not to input 2. What relationship do the waveforms at B and C have to the input? We input a 60mVp-p sine wave and the output at B was a 1.92Vp-p inverted sine wave and the output at C was a 1.85Vp-p sine wave as shown below. In summary the waveform at B is the inverse of the input and the waveform at C is the same as the input.
Background image of page 2
Measure the differential gain from the input to point C. Differential
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 4
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 5

Lab #16 - JaclynAucoin Summer2003Sec1 Lab#16

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online