{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

Lab View 4

# Lab View 4 - Randall Robert SSN 9771 EE 3221 05 Lab View 4...

This preview shows pages 1–4. Sign up to view the full content.

Randall Robert SSN – 9771 EE 3221 – 05 Lab View 4 November, 11, 2004 Lab Partner: Jason McAllister 1

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Components Used in this Lab 10kΩ reisitor R 1 100kΩ resistor R f 1μF cap C 1 0.1μF cap C f 741 Op Amp Exercise 4-1 Measurement of the Circuit Components Values Use elvis’s built in DMM feature to measure the component values Component NIELVIS Reading Assigned Value R 1 9.95kΩ 10kΩ nominal R f 97.56kΩ 100kΩ nominal C 1 1.02μF 1μF nominal C f 0.0097μF .01μF nominal Exercise 4-2 Frequency Response of the Basic Op Amp Circuit On the workstation protoboard, build a simple 741 inverting op amp circuit with a gain of ten, as shown in the schematic diagram below. ٠ After setting the function generator to the following parameters; Waveform : Sine Wave Peak Amplitude : 0.1V Frequency : 1kHz DC Offset :0.0V 2
Elvis Reading Exercise 4-3 Measuring the Op Amp Frequency Characteristic The best way to stucy the op amp’s ac characteristic response curve is to measure its Bode plot. It is basically a plot of gain an phase as a function of log frequency.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 6

Lab View 4 - Randall Robert SSN 9771 EE 3221 05 Lab View 4...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online