This preview shows page 1. Sign up to view the full content.
Unformatted text preview: FRONT END is at TOP of this picture If the front end has 3 LEDs (small bulbs) protruding slightly from 3 holes, it is an infrared device and will not work . If the front end is smooth, with a flat black plastic insert covering the three holes, it is a radio frequency device and it will work! Setting the Channel (1) Hold the double down arrow button for a few seconds until the LED turns solid red. That button is located at the bottom of the clicker: (2) Press the 2 digit channel number. For lecture room A102, it is channel 01, and for room A118 it is channel 02. You must press first the J/0 key and then either A/1 or B/2 (3) Hold the double down arrow button again for a few seconds, and the LED will flash green. This means you channel is set. It should remain set forever, unless the battery dies or something (like a book in your backpack) pushes the double down arrow button....
View Full Document
This note was uploaded on 03/02/2012 for the course PHYS 17328 taught by Professor Darilpedigo during the Spring '09 term at University of Washington.
- Spring '09