CCNA 2 Chapter 5 V4.0

CCNA 2 Chapter 5 V4.0 - 1. Refer to the exhibit. The...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
1. Refer to the exhibit . The network that is shown is running RIPv1. The 192.168.10.0/24 network was recently added and will only contain end users. What command or set of commands should be entered on Router1 to prevent RIPv1 updates from being sent to the end user devices on the new network while still allowing this new network to be advertised to other routers? Router1(config-router)# no router rip Router1(config-router)# network 192.168.10.0 Router1(config-router)# no network 192.168.10.0 Router1(config-router)# passive- interface fastethernet 0/0 Router1(config-router)# passive-interface serial 0/0/0 2. Refer to the output from the show ip route command. What can be concluded from the output of this router command? A preferred route to the destination has not been set. There are two equal cost paths to network 1.0.0.0. Both interfaces are being used equally to route traffic. A variance must be set to load-balance across multiple paths. 3. Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still in the Router1 routing table. How much longer will Router1 keep the down network in its routing table before marking it as possibly down? 30 seconds 90 seconds 155 seconds 180 seconds 255 seconds 4. What is the default update period in seconds for the RIP routing protocol? 10 12 15 20 30 60 5. Which of the following is considered a limitation of RIP v1? RIP v1 does not send subnet mask information in its updates. RIP v1 is not widely supported by networking hardware vendors.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
RIP v1 consumes excessive bandwidth by multicasting routing updates using a Class D address. RIP v1 requires enhanced router processors and extra RAM to function effectively. RIP v1 does not support load balancing across equal-cost paths. RIP v1 authentication is complicated and time-consuming to configure. 6. Which command will display RIP activity as it occurs on a router?
Background image of page 2
Image of page 3
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 03/12/2012 for the course IT 202 taught by Professor D during the Fall '10 term at University of Houston.

Page1 / 8

CCNA 2 Chapter 5 V4.0 - 1. Refer to the exhibit. The...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online