CCNA 2 Chapter 7 V4.0

CCNA 2 Chapter 7 V4.0 - 1. A network administrator has been...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
1. A network administrator has been told that the company IP address infrastructure must adhere to RFC 1918. What three IP address ranges from RFC 1918 could the administrator use on the network ? (Choose three.) 10.0.0.0/8 127.0.0.0/8 169.254.0.0/16 172.16.0.0/12 192.168.0.0/16 209.165.201.0/27 2. Refer to the exhibit. Routers East and West are configured using RIPv1. Both routers are sending updates about their directly connected routes. The East router can ping the West router serial interface and West can ping the serial interface of East. However, neither router has dynamically learned routes from the other. What is most likely the problem? A gateway of last resort is required. Subnetting is not supported by RIPv1. VLSM is not supported by RIPv1. One of the routers needs a clock rate on the serial interface. 3. Refer to the exhibit. What effect will the commands that are shown have on RIP updates for Router1? Only version 2 updates are sent to 255.255.255.255. Only version 2 updates are sent to 224.0.0.9. Both version 1 and version 2 updates are sent to 224.0.0.9. Both version 1 and version 2 updates are sent to 255.255.255.255.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
4. Refer to the exhibit. What can be concluded from the output shown in the exhibit? The routing table is limited to 2 routes. The LAN interfaces are participating in the routing process. One update has been sent out of each serial interface and 2 have been received. The no auto-summary has not been configured on this router. 5. What are two reasons to implement RIP version 2 rather than RIP version 1? (Choose two.) RIP version 2 supports VLSM. RIP version 2 supports more than 16 routers. RIP version 2 supports classful (and not classless) routing. RIP version 2 supports routing update authentication. RIP version 2 supports multi-areas. RIP version 2 uses the Dijkstra algorithm rather than the Bellman-Ford algorithm. 6.
Background image of page 2
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on each router:
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 4
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 03/12/2012 for the course IT 202 taught by Professor D during the Fall '10 term at University of Houston.

Page1 / 8

CCNA 2 Chapter 7 V4.0 - 1. A network administrator has been...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online