Mathcad - 13-08 and 09 - CM ft = D for copper . 10.371 (...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
A 70 amp fuse is the next lowest, so it would be the largest allowable fuse. However, if it did not allow the motor to start then the next size could be used--80 amps. MaxFuse 75.9A = MaxFuse 3 FLA = From table 430-152, the maximum size single element fuse is 300% of FLA FLA 25.3 amp = From table 430-150, the rated FLA for a 7.5 hp motor at 200 volts is Problem 13-9: Solution R 9.343 10 4 - × = R ρ l Area = l 100 ft = ρ 10.371
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 2
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: CM ft = D for copper . 10.371 ( S-cmil) per ft Area 1.11 10 3 kcmil = Area 2000 mils ( ) 2 1700 mils ( ) 2-= Therefore the area in CM is or 1700 mils ID 1.7 in = or 2000 mils OD 2 in = The area of the pipe is the area of a solid conductor with the same radius of the pipe minus the area of the hole in the center: Problem 13-8: Solution...
View Full Document

This note was uploaded on 03/26/2012 for the course ECET 231 taught by Professor Piller during the Spring '12 term at Purdue University-West Lafayette.

Page1 / 2

Mathcad - 13-08 and 09 - CM ft = D for copper . 10.371 (...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online