This preview shows page 1. Sign up to view the full content.
Unformatted text preview: c. Label the timer numbers, bases, and presets, assuming the desired time delay is 10 seconds for the blower to turn on after the heater starts and 45 seconds to turn off after the heater stops. Addresses for single-slot addressing: With one-slot addressing, each slot is an I/O group, so slot 2 will be I/O group 2 and slot 3 will be I/O group 3. stop: I:002/00 green lamp: O:003/00 start: I:002/01 motor starter: O:003/01 thermostat 1: I:002/02 heater: O:003/02 thermostat 2: I:002/03 red lamp: O:003/03...
View Full Document
This note was uploaded on 03/26/2012 for the course ECET 231 taught by Professor Piller during the Spring '12 term at Purdue.
- Spring '12