{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

ECE 231 HW-6 Solution Set

# ECE 231 HW-6 Solution Set - ECE-231 Circuits and Systems I...

This preview shows pages 1–9. Sign up to view the full content.

ECE-231 Circuits and Systems I Spring 2011 HW Set #6 Professor Stewart Personick ECEC-321 [email protected]

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Instructions Send your solution set, via E-mail, to: [email protected] The “subject” of your E-mail must be : ECE 231 HW#6 (your last name) Your solution set must be in the form of an attachment. I.e. a Microsoft Office file (.doc, .docx, .xls, .xlsx, .ppt, .pptx, .pdf) or a legible scan of a handwritten file. Your solution set must be sent to me by the deadline: Sunday, February 27, 8 p.m. Eastern time. [Drafts will be accepted for
HW#6 Problem 1 Start with the LTSpice IV file: HW5 Problem 3.asc (posted on the course web site) Modify the schematic to set the amplitude of V1 to zero volts. Then simulate (i.e. do three (3) separate simulation runs) the voltage waveform at the output of the circuit (i.e. at node n003) for values of the amplitude of V2 equal to: 0.25V, 0.5V, and 1V . n004 n006 n003

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Problem 1: V1=0V V2= 0.25V
Problem 1: V1=0V V2= 0.25V

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Problem 1: V1=0V V2= 0.5V
Problem 1: V1=0V V2= 1V

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
HW#6 Problem 2
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}