where l is the length of the cylinder and area is

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: .. (where l is the length of the cylinder and area is the projected area) σc m σl and net circumferential stress = σc − m The thickness of a cylinder wall (t) is usually obtained by using a thin cylindrical formula,i.e., p×D +C t = 2σ c where p = Maximum pressure inside the cylinder in N/mm2, D = Inside diameter of the cylinder or cylinder bore in mm, ∴ Net longitudinal stress = σl − σc = Permissible circumferential or hoop stress for the cylinder material in MPa or N/mm2. Its value may be taken from 35 MPa to 100 MPa depending upon the size and material of the cylinder. C = Allowance for reboring. The allowance for reboring (C ) depending upon the cylinder bore (D) for I. C. engines is given in the following table : Table 32.1. Allowance for reboring for I. C. engine cylinders. D (mm) 75 100 150 200 250 300 350 400 450 500 C (mm) 1.5 2.4 4.0 6.3 8.0 9.5 11.0 12.5 12.5 12.5 The thickness of the cylinder wall usually varies from 4.5 mm to 25 mm or more depending upon the size of the cylinder....
View Full Document

This note was uploaded on 09/30/2012 for the course MECHANICAL 403 taught by Professor A.thirumoorthy during the Spring '11 term at Anna University Chennai - Regional Office, Coimbatore.

Ask a homework question - tutors are online