Bn1 bk4 bu3 bn1 bk4 bu3 24 v dc l 0v load

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: e technology © Festo Didactic GmbH & Co. KG • FP 1110 149 10. Connection and circuit technology 10.3.3 Parallel connection of proximity sensors using three-wire technology Parallel connection of proximity sensors in three-wire technology can be achieved without any problems. The following points must be observed: • In the unswitched status, the low residual currents of the parallel connected proximity sensors accumulate (simultaneous use of mechanical contacts and proximity sensors is possible). • If proximity sensors with an output stage in the form of an open-collector circuit are used, then there is no mutual effect. In the case of proximity sensors with different switch outputs, decoupling diodes are necessary (see Fig. 10.3.2). The diodes are usually integrated in the sensor for the purpose of reverse polarity protection. BN(1) BK(4) BU(3) BN(1) BK(4) BU(3) + 24 V DC L 0V Load (L) Fig. 10.3.2: Parallel connection in three-wire technology (DC) Direct current three-wire proximity sensors can be parallel...
View Full Document

This note was uploaded on 11/01/2012 for the course CHEMICAL 102 taught by Professor Jamesrodriguez during the Spring '12 term at Universidad Politécnica de Cartagena.

Ask a homework question - tutors are online