Electronic Circuits I LAB 4.docx - Table of Contents 1...

This preview shows page 1 - 7 out of 14 pages.

Table of Contents 1. Introduction ........................................................................................... 1 2. Objectives .............................................................................................. 2 3. Circuit under Test .................................................................................. 2-3 4. Experimental Results ............................................................................ 3-6 5. Conclusions and Remarks ..................................................................... 6-7 6.Appendix: Signed Pre-Lab and TA Copy of Results ......................... 8-14
Introduction The lab 4 report, Wave Shaping Circuits, is presented herein. The lab took place on July 10 2020. The pre-lab is at the end of the report in the appendix. Objective The objective of this lab is to examine the ability of a diode circuit to change an input signal into a more desirable waveform. This ability capitalizes on the unique characteristics of the diode circuit. Circuit Under Test The following figure contains the circuit being used for the experiment. Figure 1: Circuit for E1 1
Figure 2: Circuit for E2 Figure 3: Circuit for E3 2
Experimental Results Figure 4: Graph E1A Figure 5: Graph E1B 3
Figure 6: Graph E2A Figure 7: Graph E2B 4
Figure 8: Graph E3A Figure 9: Graph E3B Conclusion and Results This is the section where the questions presented in the lab manual are answered some of the questions are pasted in bold for reference.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture