Plumbing_Homework Problems.pdf - ITEC 360 Plumbing Homework...

This preview shows page 1 - 2 out of 3 pages.

ITEC 360: Plumbing Homework Problem 1 The diagram shown in the restroom elevations (on Canvas) represents three elevations of a typical accessible single-toilet facility. The letters indicated in the diagram correspond to the letters listed here. Fill in the typical dimension as required by the current codes and accessibility standards for each of the following in the spaces provided. (Indicate the most restrictive requirement.) Be sure to indicate the unit of measure (e.g. inches). Add the words minimum and maximum where applicable. Refer to the images in the lecture study slides to answer the questions below. Note: You may need to reference a plan view to get an answer for an elevation dimension. A. Depth of lavatory_________________________________________ B. Height clearance of kneespace_______________________________ C. Height clearance of toespace________________________________ D. Height to top of lavatory____________________________________ E. Length of rear grab bar_____________________________________ F. Distance from end of rear grab bar to centerline of toilet on side wall __________ G. Height to grab bar_________________________________________ H. Height to top of toilet seat__________________________________ I.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture