E Lab report 1

E Lab report 1 - Step 3: We followed the Lab Manual. Step...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
Objective: To test KVL, KCL, and Ohms law on simple circuits, also to see the effects of wiring resistors, in series or in parallel, to show corresponding resistances. Circuit Diagram: Figure 1: Resistors set in series with each other. Figure 2: Resistors set in parallel with each other. Figure 3: Measurement across single resistor. Figure 5: Measurement taken across resistors in parallel. Figure 4: Measurement taken across the resistors in series. Measurement of Current through resistors in parallel 5.1471mA Figure 6: Measurement taken across resistors in series.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Procedure: Step 1: We followed the same procedure that was given to us in the Lab Manual; we experienced no issues, finding resistors with the correct amount of Ohms. We tested the 1K resistors to find that they fit in the range of preferred resistance (± 5%, 950Ω - 1050Ω). Step 2: We followed the Lab Manual as directed; the only difference we experienced was the adjusted voltage of the power supply. We set the supply to 5.05V because the target setting of 5V could not be obtained due to the sensitivity of the voltage adjuster.
Background image of page 2
Background image of page 3
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Step 3: We followed the Lab Manual. Step 4: We followed the Lab Manual. Step 5: We followed the Lab Manual. Step 6: We followed the Lab Manual. Step 7: We followed the Lab Manual. Tables: Device Nominal Value Actual Value R1 1000 980.1 R2 1000 977.8 Device Nominal Value Actual Value Power Supply (PS) 5V 5.080V Table 1: Actual value of resistor compared to Nominal value Table 2: Actual value of power supply compared to Nominal value Device PS Voltage Nominal Value Actual Value Measured Current R1 5.080V 1000 980.1 5.1656mA Device PS Voltage Nominal Value Actual Value Measured Current R1 & R2 5.080V 2000 1958 2.588mA Device Nominal Value Actual Value Measured Voltage R1 1000 980.1 2.5429V R2 1000 977.8 2.5387V PS 5V 5.080V 5.080V Table 3: Measured current going through R1 Table 4: Measured current through R1 & R2 in a Series Table 5: Measured currents through R1 & R2 in a series...
View Full Document

Page1 / 3

E Lab report 1 - Step 3: We followed the Lab Manual. Step...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online