E lab report 4

# E lab report 4 - Objective In this lab we had to convert a...

This preview shows pages 1–3. Sign up to view the full content.

Objective: In this lab we had to convert a 9V source into a constant 5V source. This was necessary to test because it is the voltage converter that will be used in the robots circuits. Circuit Diagrams / Schematics: Figure 1: The Voltage Regulator Procedure: Step 1: Followed the lab procedure found on page 47-48 of the Lab Manual. Step 2: Followed the lab procedure found on page 48 of the Lab Manual. Step 3: Followed the lab procedure found on page 48-49 of the Lab Manual. Step 4: Followed the lab procedure found on page 49 of the Lab Manual. Data/ Plots/ Tables/ Graphs: Nominal Voltage (V) V In (V) V Out (V) 0.0 0.0146 -0.0031 1.0 1.0441 0.4702 2.0 2.0415 1.4155 3.0 3.0511 2.5165 4.0 4.0352 3.4305 5.0 5.0523 4.1253 6.0 6.0424 5.0404 7.0 7.0431 5.0765 8.0 8.0411 5.0822 9.0 9.0391 5.1216 Table 1: Data deduced from increasing the voltage in 1V intervals.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Graph of Table 1 -1 0 1 2 3 4 5 6 0 2 4 6 8 10 V In V Out Series1 8 8.0411 5.0822 9 9.0391 5.1216 Table 2: Data taken from Table 1 to calculate line regulation. Formula for Line Regulation:
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 04/07/2008 for the course ENGR 101 taught by Professor Gulla during the Fall '06 term at VCU.

### Page1 / 3

E lab report 4 - Objective In this lab we had to convert a...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online