{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

Thevenin Theorem and Power Transfer

# Thevenin Theorem and Power Transfer - Author Abdul Course...

This preview shows pages 1–3. Sign up to view the full content.

Author: Abdul Course: Electrical Engineering Lab EE-P202 Experiment 6: “Thevenin Theorem and Power Transfer”

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Objective : The objective of this experiment was to study and verify Thevenin’s Theorem and to determine the condition for maximum power transfer. Equipment : The equipment in this lab included a digital multi-meter, a DC power supply, five different resistors, and a resistance decade box. The resistors included 560 and 680 Ohm resistors. Procedure : Connect the circuit of Figure 6.2 and note the load of the resistance decade box is disconnected. Continue by measuring the open circuit voltage across point A to B with the DMM. Record this voltage value as VTH. Then continue by connecting the circuit of Figure 6.3 and measure the short circuit current by using the DMM between points A and B and record this current value as IN. Then disconnect the source and connect the two points together as shown in Figure 6.4 and measure the resistance from point A to B with the DMM. This resistance should be recorded as RTH. These three
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 4

Thevenin Theorem and Power Transfer - Author Abdul Course...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online