Voltage Divider and Current Divider

# Voltage Divider and Current Divider - Author abdul Course...

This preview shows pages 1–3. Sign up to view the full content.

Author: abdul Course: Electrical Engineering Lab EE-P202 Experiment 3: “Voltage Divider and Current Divider”

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Objective : The objective of this experiment was to become familiar with the theory and formulas for voltage and current division. Equipment : The equipment in this lab included a digital multi-meter, a DC power supply, and eight different resistors. These resistors included a 100, 220, 330, 470, 1000, 2700, and 6800 Ohm resistors. Procedure : Connect the circuit of Figure 3.1 without the DC power supply on. Use the digital multi-meter to measure voltages V(2) and V(3) and use the ammeter to measure I(t). Then connect the circuit of Figure 3.2 and adjust the input voltage until the I(t) reads 5mA on the ammeter. After that, remove the ammeter and use it to measure the currents I(2) and I(3). Then continue by connecting the circuit of Figure 3.3 and measure V(ad), V(bc), and V(ab) with the digital multi-meter. Lastly, connect the circuit of Figure 3.4 and measure V(4) with the digital multi-meter. Remember, while measuring
This is the end of the preview. Sign up to access the rest of the document.

## This lab report was uploaded on 04/07/2008 for the course EENG 201 taught by Professor Mallik during the Spring '08 term at Saint Louis.

### Page1 / 3

Voltage Divider and Current Divider - Author abdul Course...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online