Building Code of the Philippines(1)

Or paths can be given defined edges either by the use

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: m; 1.5 A walkway from accessible spaces of 1.20 m. clear width shall be provided between the front ends of parked cars; 1.6 Provide dropped durbs or curb cut-outs to the parkfing level where access walkways are raised; 1.7 Pavement markings, signs or other means shall be provided to delineate parking spaces for the handicapped; 1.8 Parking spaces for the disabled should never be located at ramped or sloping areas; C. INSIDE BUILDINGS AND STRUCTURES 1. ENTRANCES 1.1 Entrances should be accessible from arrival and departure points to the interior lobby; 1.2 One (1) entrances level should be provided where elevators are accessible; 1.3 In case entrances are not on the same level of the site arrival grade, ramps should be provided as access to the entrance level; 1.4 Entrances with vestibules shall be provided a level area with at least a 1.80 m. depth and a 1.50 m. width; 2. RAMPS 2.1 Changes in level require a ramp except when served by a dropped curb, an elevator or other mechanical device; 2.2 Ramps shall have a minimum clear width of 1.20 m; 2.3 The maximum gradient shall be 1:12; 2.4 The length of a ramp should not exceed 6.00 m. if the gradient is 1:12; longer ramps whose gradient is 1:12 shall be provided with landings not less than 1.50 m; 2.5 A level area not less than 1.80 m. should be provided at the top and bottom of any ramp; 2.6 Handrails will be provided on both sides of the ramp at 0.70 m. and 0.90 m. from the ramp level; 2.7 Ramps shall be equipped with curbs on both sides with a minimum height of 0.10 m.; 2.8 Any ramp with a rise greater than 0.20 m. and leads down towards an area where vehicular traffic is possible, should have a railing across the full width of its lower end, not less than 1.80 meters fromt he foot of the ramp; 3. DOORS 3.1 All doors shall have a minimum clear width of 0.80 m; 3.2 Clear openings shall be measured betweent he surface of the fully open door at the hinge and the door jamb at the stop; 3.3 Doors should be operable by a pressure or force not more than 4.0 kg; the closing device pressure an interior door shall not exceed 1 kg.; 3.4 A minimum clear level space of 1.50 m x 1.50 m shall be provided before and extending beyond a door; EXCEPT: where a door shall open onto but not into a corridor, the required clear, level space on the corridor side of the door may be a minimum of 1.20 m corridor width; 3.5 Protection should be provided from doors that swing into corridors; 3.6 Outswinging doors should be provided at storage rooms, closets and accesssible restroom stalls; 3.7 Latching or non-latching hardware should not require wrist action or fine finger manipulation; 3.8 Doorknobs and other hardware should be located between 0.82 m. and 1.05 m. above the floor; 0.90 is preferred; 3.9 Vertical pull handles, centered at 1.06 m. above the floor, are preferred to horizontal pull bars for swing doors or doors with locking devices; 3.10 Doors along major circulation routes should be provided with kick plates mad...
View Full Document

{[ snackBarMessage ]}

Ask a homework question - tutors are online