OOMA User Guide

Ordered see cannibalization wizard urgent with

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: (see "Cannibalization Wizard - Urgent with Requisition being Ordered" on page 385) Chapter 5 Maintenance Subsystem 391 Cannibalization Wizard - Urgent without Requisition This cannibalization wizard is used when you select No on the Cannibalization Setup dialog box and the cannibalization action must be done expeditiously without ordering a replacement part for the defective component to fix the down aircraft immediately. The replacement part will be ordered at a later time when workload permits. Use the Back and Next buttons to move through the dialog boxes. For the complete fourstep process, see the following topics: ! Step 1 - MCN/Data Validation (on page 391) ! Step 2 - Source Aircraft Part/Position Selection (on page 391) ! Step 3 - Removal/Install Signatures and Serno Entry (on page 391) ! Step 4 - Cannibalization Work Order Fill In (on page 392) Step 1 - MCN/Data Validation This dialog box appears with two tabs: Select Repairable and Select Consumables. The box reflects information on the removed component, its WUC/UNS, where the component was removed, and where it is installed. The box is for viewing only to ensure that before continuing the process, the data is validated to be correct. 1 Click Next. The Source Aircraft Part/Position Selection dialog box appears. 2 Go to Step 2 (see "Step 2 - Source Aircraft Part/Position Selection" on page 387). Step 2 - Source Aircraft Part/Position Selection This dialog box identifies the component's system, part, WUC/UNS, and its position as the source from which the cannibalized part will be removed. 1 Select the appropriate WUC/UNS, part, and position. 2 Click Next. The Removal/Install Signatures and Serno Entry dialog box appears. 3 Go to Step 3 (see "Step 3 - Removal/Install Signatures and Serno Entry" on page 391). Step 3 - Removal/Install Signatures and Serno Entry This dialog box enables you to identify the serial number of the component that was removed, to be installed on the target aircraft WUC/UNS, part, and position. 1 Click Next. The Cannibalization Work Order Fill In dialog box appears. 2 Go to Step 4 (see "Step 4 - Cannibalization Work Order Fill In" on page 392). 392 User Guide Optimized NALCOMIS OMA Step 4 - Cannibalization Work Order Fill In This dialog box containing the description, system reason, work center, and the create/received date enables you to identify the cannibalization work order that was filled in for the target aircraft. This cannibalization work order was filled in for the target aircraft with the component's position, nomenclature, and DDSN, which is to be determined at this point. 1 Click Finish. 2 Click OK on the MCN and JCN Assignments dialog box. 3 On the Aircraft VED, respond to the Print prompt accordingly. 4 The Aircraft VED reappears, which reflects a new Incomplete Cannibalization icon next to the aircraft icon. For procedures on completing the incomplete cannibalization, see Cannibalization Wizard - Finish Incomplete Cannibali...
View Full Document

Ask a homework question - tutors are online