This preview shows page 1. Sign up to view the full content.
Unformatted text preview: Work Order
The Inspections/Removals option on the VEDs enables you to initiate or
query all inspections against Aircraft, SE, ALSS, MME, and Uninstalled
Equipment items or initiate component removal for all, except
Uninstalled Equipment items.
Inspections are based on the established +/-3 days
(days/weeks/month/year) interval codes.
Component removals are based on the established +/-10 percent
(hourly/event) interval codes.
1 Open the specific VED (see "Open a VED" on page 342). Chapter 5 Maintenance Subsystem 449 2 Right-click the Modex or Serno, choose Initiate, then
Inspections/Removals, and select Aircraft Inspections or
The appropriate window appears depending upon your selection.
For procedures, see the applicable topic listed under "In This Section."
Inspections - Aircraft
This window appears when you initiate a near due inspection work order
against aircraft. The Initiate>Aircraft Inspections option enables you to
query near due inspections. Usage values in the Maintenance Subsystem
displays 3 digits to the right of the decimal when the usage requires it
(3456.917). In some cases where the usage value is only in tenths, the
usage displays in either tenths (3456.9) or 3 digits (3456.900).
For procedures, click the following topics:
! Initiate a Near Due Inspection for Aircraft (on page 449) ! Initiate a Conditional Inspection for Aircraft (on page 450) ! Initiate a Preservation/Depreservation Inspection for Aircraft (on
page 450) Initiate a Near Due Inspection for Aircraft
1 Open the Aircraft VED (see "Open a VED" on page 342).
2 Right-click the Modex and choose Initiate, then
Inspections/Removals, and select Aircraft Inspections.
3 On the Inspections - Aircraft window, enter the Modex and
BUNO/Serno for a specific aircraft. For all aircraft, leave the
BUNO/Serno field blank.
4 Select the specific intervals (Days, Hours, Events, and Phase) or leave
them blank for all intervals and click Retrieve.
Note: If you select the IMC/SDLM option, a list of IMC inspections
that are due appears.
5 The lower portion of the window displays the inspections and its
related information based on the criteria used.
6 To issue the inspection work order, select the specific inspection and
7 The Control JCN appears alongside the Print prompt.
Note 1: When you initiate the IMC/SDLM inspection and the
information message appears to prompt the user that 'Initiation of
IMC inspection requires a change in XRAY status. Contact Logs
& Records Administrator' appears after the JCN assignment.
Note 2: When the Attention box prompts you that there is no work
center assigned to perform the selected inspection, go to Table
Maintenance menu and select Inspection Work Center and assign a
work center for the inspection. For procedures, see Inspection Work
Center (on page 481). 450 User Guide Optimized NALCOMIS OMA 8 Respond to the Print prompt accordingly.
9 Click Retrieve and repeat steps 5 and 6 to ini...
View Full Document
- Fall '13