HomeworkAssignment04Solution

# 2 0006 680 528 v 9 thus an engineer measures finds

This preview shows page 1. Sign up to view the full content.

This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: = 5.28 V 9. ? . Thus, An engineer measures finds that with an input voltage , the output voltage is , so that the gain of the amplifier is 6. However, op-amp theory suggests the ⁄ gain is . Give one phrase that could explain the difference. Slew-rate 10. The output voltage of a three-terminal voltage regulator is 5 V @ 5 mA load, and 4.96 V @ 1.5 A load. What is the regulator’s output resistance? Answer. ⁄ ⁄ 2 55:041 Electronic Circuits. The University of Iowa. Fall 2011. 11. Below are the characteristics for a MOSFET. What type of FET is this (circle one)? (a) Enhancement PMOS (b) Enhancement NMOS (c) Depletion NMOS Answer: Depletion NMOS => (b) 12. Below as possible ordering for (a) (b) (c) (d) ( ( ( ( ( for several LEDs. Circle the correct one. ( ( ( ( ( ( ( ( ( ( ( Answer: (a) 13. True or false: in MOSFETs the drain current is directly proportional to the width-to-length ratio. Answer: True 14. Briefly explain (1–2 sentences) what is ( as it pertains to MOSFETs. (2 points) This is the lower channel resistance that one can achieve when turning on a MOSFET. That’s is, the resistance between drain and source when (for an NMOSFET). 3 55:041 Electronic Circuits. The University of Iowa. Fall 2011. 15. True or false: given the symmetrical construction of MOSFETs one can, in principle, at least, interchange the drain and the source terminals without affecting device behavior. Answer: True 16. Below is a...
View Full Document

## This note was uploaded on 10/26/2013 for the course ECE 55:041 taught by Professor Kruger during the Fall '11 term at University of Iowa.

Ask a homework question - tutors are online