This preview shows page 1. Sign up to view the full content.
Unformatted text preview: contouring. S E SP At the beginning of process, the tool quill should be at machine home position H0. Take SP (0,0)
as fixture offset position H1 and tool height offset position O1. Start contouring from S and move
in anti-clockwise direction and end at point E. After completion, the tool should come back to its
home position H0 E2 - 1 Solution for Exercise - 2
1) Set up for machine
(a) Mount the workpiece on machine table with clamps as shown in Figure 1. The workpiece is
raised from the table to avoid the tool touching the table during cu...
View Full Document
This document was uploaded on 12/06/2013.
- Fall '13
- Mechanical Engineering