This preview shows page 1. Sign up to view the full content.
Unformatted text preview: tting.
(b) Align the machine to its home position (machine reference position) H0, as shown in Figure 1. Note: Figure 1. Tool at Machine reference (home) position H0
The X table is on extreme right and Y table is extreme in position
where as tool quill is on extreme top position. (c) Replace the tool with the required 10mm diameter rough end mill cutter.
(d) Enter required information of the tool in tool data table of software as T1.
(e) Move the table in X and Y direction and tool in Z direction until the tip of tool touches the top
and SP location of the workpiece as shown in Figure...
View Full Document
This document was uploaded on 12/06/2013.
- Fall '13
- Mechanical Engineering