Choose add to add the device and associated

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: ogram Design Laboratory Package User Guide 5. Choose Add to add the device and associated programming file to the Device Names & Programming File Names box. The number to the left of the device name shows the order of the device in the JTAG chain. The device’s associated programming file is displayed on the same line as the device name. If no programming file is associated with a device, “<none>” is displayed next to the device name. 6. Choose Detect JTAG Chain Info to have the ByteBlaster check the device count, JTAG ID code, and total instruction length of the JTAG chain. A message just above the Detect JTAG Chain Info button reports the information detected by the ByteBlaster. You must manually verify that this message matches the information in the Device Names & Programming File Names box. 7. To save the current settings to a JTAG Chain File (.jcf) for future use, choose Save JCF. In the Save JCF dialog box, type the name of the file in the File Name box and then select the desired directory in the Directories box. Choose OK. 8. Choose OK to save your changes. 9. In the MAX+PLUS II Programmer, choose Program. EPF10K20 Configuration This section describes the procedures for configuring only the EPF10K20 device, (i.e., how to set the on-board jumpers, connect the ByteBlaster download cable, and set options in the MAX+PLUS II software). Setting the On-Board Jumpers for EPF10K20 Configuration To configure only the EPF10K20 device in a JTAG chain, set the jumpers TDI, TDO, DEVICE, and BOARD as shown in Figure 8. Figure 8. Jumper Settings for Configuring Only the EPF10K20 Device TDI C1 C1 C1 C1 C2 C2 C2 C2 C3 20 TDO DEVICE BOARD C3 C3 C3 Altera Corporation University Program Design Laboratory Package User Guide Connecting the ByteBlaster Download Cable for EPF10K20 Configuration Attach the ByteBlaster directly to the PC’s parallel port and to the JTAG_IN connector on the UP 1 Education Board. For more information on setting up the ByteBlaster, go to the ByteBlaster Parallel Port Download Cable Data Sheet. Setting the JTAG Options in MAX+PLUS II for EPF10K20 Configuration The following s...
View Full Document

This document was uploaded on 02/25/2014.

Ask a homework question - tutors are online