{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

ELEC20402 Experiment 6

# ELEC20402 Experiment 6 - ELEC204-02 Technical Report for...

This preview shows pages 1–4. Sign up to view the full content.

ELEC204-02 Technical Report for Lab Experiment #6 RC Circuits Submitted by: D. Bunn T. Seabolt Date of Submission March 7 th , 2007

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Purpose of experiment To model AC RC circuits and obtain measurements from them. Model numbers of equipment used HP33210A Waveform Generator Agilent 54622D Mixed Signal Oscilloscope Jameco JE24 Breadboard Circuit Schematics Part A: V 1 T D = 0 T F = 0 P W = . 0 0 4 P E R = . 0 1 V 1 = . 5 T R = 0 V 2 = - . 5 R 1 1 k R 2 3 8 . 3 k R 3 2 . 2 k C 1 . 0 1 u F V Part B: R 1 1 k R 2 3 8 . 3 k R 3 2 . 2 k C 1 . 0 1 u F V V 1 1 V a c 0 V d c Part C: R 3 3 . 2 k C 1 . 0 1 u F V V 1 V s Block diagram of test set up Test Procedure Equations used % error = (measured – theoretical) / theoretical * 100 Part A: The circuit pictured above for Part A was replicated on a breadboard after measuring the resistance and/or capacitance of each element. The function generator was attached outputting a square waveform at 100, 1000, or 10000 Hz frequency and 512
mVpp amplitude (40% duty cycle). The peak-to-peak voltage and the rise and fall times were measured and recorded by the oscilloscope.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 5

ELEC20402 Experiment 6 - ELEC204-02 Technical Report for...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online