ELEC20402 Experiment 8

ELEC20402 Experiment 8 - ELEC204-02 Technical Report for...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
ELEC204-02 Technical Report for Lab Experiment #8 Single-Phase AC Power Measurements Submitted by: D. Bunn T. Seabolt Date of Submission April 4 th , 2007
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Purpose of experiment To get an introduction to the LabVolt rack while demonstrating power factor correction. Model numbers of equipment used LabVolt EMS 8311-00 Variable Resistance LabVolt EMS 8331-00 Variable Capacitance LabVolt EMS 8321-00 Variable Inductance LabVolt EMS 8821 Power Source Fluke 8010A Digital Multimeter Circuit Schematics Circuit A: V s R 1 3 0 0 L 1 . 8 H 1 2 60 Hz 40Vrms Circuit B: V s R 1 3 0 0 L 1 . 8 H 1 2 60 Hz 40Vrms C 1 4 . 4 2 u F Block diagram of test set up Circuit A: Circuit B: Test Procedure Circuit A
Background image of page 2
Using the LabVolt modules, a 300-ohm resistance was selected on the Variable Resistance, and a .8H inductance on the Variable Inductance. The resistor and inductor were connected in series, and the two multimeters attached to measure the current and voltage in the circuit. The circuit was then connected to the variable AC voltage source,
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 4
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 4

ELEC20402 Experiment 8 - ELEC204-02 Technical Report for...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online