ELEC31301 Experiment 3

ELEC31301 Experiment 3 - ELEC313-01 Technical Report for...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
ELEC313-01 Technical Report for Lab Experiment #3 Diode Circuits Submitted by: D. Bunn E. Muniz M. Schmick Date of Submission September 25 th , 2007
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Purpose of experiment: To construct, measure, and observe the behavior of a diode rectifier circuit and voltage regulator circuit. Model numbers of equipment used Hewlett-Packard HPE3631A Power Supply Hewlett-Packard HP33120A Function Generator Agilent 546220 Mixed Signal Oscilloscope Fluke 8010A Digital Multimeter Jameco JE24 Breadboard Block diagram of test set up Diagram A: Rectifier Circuit Diagram B: Voltage Regulator Circuit Circuit schematic Schematic A: Voltage Regulator
Background image of page 2
Schematic B: Rectifier Test Procedure Rectifier Circuit The circuit shown in Schematic A was constructed on the breadboard. The resistance was initially set at 10K ohms. The oscilloscope’s channels were then connected to the function generator’s output and the load voltage output. The function generator was set to a 400Hz sine wave, with a 1V peak amplitude. The multimeter was
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 4
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 5

ELEC31301 Experiment 3 - ELEC313-01 Technical Report for...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online