ELEC31301 Experiment 6

ELEC31301 Experiment 6 - ELEC313-01 Technical Report for...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
ELEC313-01 Technical Report for Lab Experiment #6 Bipolar Junction Transistor Biasing Submitted by: D. Bunn M. Kaspar Date of Submission October 9 th , 2007
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Purpose of experiment: The purpose of the experiment is to observe the temperature stability of three different emitter circuits. Model numbers of equipment used Hewlett-Packard HPE3631A Power Supply Hewlett-Packard HP34401A Multimeter Fluke 8010A Digital Multimeter Jameco JE24 Breadboard Block Diagram Circuit schematic Circuit A Circuit B Circuit C
Background image of page 2
Circuit A was set up as shown above and the power supply and multi-meters were connected. Power supply was set to 10 V and current and voltage across the collector were recorded. Then a hair dryer heated the transistor for 30 sec. and the current and voltage were recorded again. Circuit B and C were set up as shown above and the same measurements were taken in the same procedure. Data
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 4
This is the end of the preview. Sign up to access the rest of the document.

This lab report was uploaded on 04/08/2008 for the course ELEC 313 taught by Professor Barsanti during the Fall '07 term at Citadel.

Page1 / 4

ELEC31301 Experiment 6 - ELEC313-01 Technical Report for...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online