This preview shows page 1. Sign up to view the full content.
Unformatted text preview: w sensor, but it is picking up low frequency noise that is affecting your measurements. Unfortunately, it is 2am and you need to demo the sensor tomorrow morning. You have a large selection of resistors and one 10mH inductor in the lab that you can use to remove the low‐frequency noise while allowing the high frequencies you are measuring to pass through normally. (Remember the time constant for an RL circuit = L/R.) A. (5pts) Draw a circuit that will accomplish this task using one resistor (R) and one inductor (L). Clearly mark the input and output voltages Vin and Vout with...
View Full Document
This test prep was uploaded on 03/21/2014 for the course ENME 350 taught by Professor Barker during the Spring '11 term at Maryland.
- Spring '11