Then you will implement inter vlan routing dhcp ripv2

This preview shows page 2 - 3 out of 3 pages.

Then, you will implement inter-VLAN routing, DHCP, RIPv2, default routing, and NAT on a router. Finally, you will use your documentation to verify your implementation by testing end-to-end connectivity.DocumentationYou are required to fully document the network. You will need a print out of this instruction set, which will include an unlabeled topology diagram:-Label all the device names, network addresses and other important information that Packet Tracer generated.-Complete the Addressing Table and VLANs and Port Assignments Table.-Fill in any blanks in the Implementation and Verification steps. The information is supplied when you launch the Packet Tracer activity.ImplementationNote: All devices in the topology except ___Central______, __Cnt-Sw______, and __NetAdmin____ are fully configured. You do not have access to the other routers. You can access all the servers and PCs for testing purposes.Implement to following requirements using your documentation:__Cnt-Sw_______Configure remote management access including IP addressing and SSH:-Domain is cisco.com-User __CAdmin______ with password _itsasecret___-Crypto key length of 1024-SSH version 2, limited to 2 authentication attempts and a 60 second timeout-

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture