A customer has installed a WLAN and wants to create an access rule that will

A customer has installed a wlan and wants to create

This preview shows page 2 - 4 out of 5 pages.

A customer has installed a WLAN and wants to create an access rule that will allow users to connect to the WLAN without authenticating. Which parameter setting will accomplish this? A. EAP type should be set to pass-through B. Encryption type should be set to "802.1x". C. Fall through authentication should be set to last Resort D. Under SNMP the security level should be set to nsecured Answer: C QUESTION: 58 A customer is performing the initial configuration on a WLAN Security Switch 2350. 19
Image of page 2
Given the following parameters: Management: VLAN=10, IP= 10.1.10.20 Data: VLAN=220, IP= 10.1.220.20 Guest: VLAN=236, IP=10.1.236.20 Which commands will establish the IP address and gateway? (Choose two.) A. set enablepass B. set ip route default C. set interface management ip D. cypto generate key web 1024 E. set vlan 10 management tag 10 port Answer: B, C QUESTION: 59 A customer has just created a Web Portal on a WLAN Security Switch (WSS) 2380 using CLI. Which command allows them to view the status of users using the portal? A. crypto generate self-signed web B. mkdir gkweb C. gkweb/wlanindex.htm D. show sessions network <ssid> Answer: D QUESTION: 60 A customer is using a SpectraLink Voice Priority (SVP) in the Telephony Manager 2245 on their network. What must be done to enable SVP to provide QoS for Voice over IP?
Image of page 3
Image of page 4

You've reached the end of your free preview.

Want to read all 5 pages?

  • Fall '20
  • IP address, Subnetwork, Dynamic Host Configuration Protocol

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture