For VCS Windows SFW HA 41 and SFW HA 42 make sure the patch available and is

For vcs windows sfw ha 41 and sfw ha 42 make sure the

This preview shows page 35 - 37 out of 77 pages.

For VCS Windows (SFW-HA 4.1 and SFW-HA 4.2) make sure the patch available and is installed before you install or upgrade to the current NetBackup version. The patch is available at the following Web site: . Note: In few cases, after the NetBackup master cluster installation, the resource is not installed into the service group. In case the resource of type "NetBackupVCS" is added manually, the attributes of NetBackupVCS are blank and this resource cannot probe on cluster servers. For work-around, contact Technical Support Team. Verify the cluster disk group(s) and dynamic volume(s) for NetBackup have been created on the shared storage. Refer to the Veritas Storage Foundation Administrator’s Guide for details on how to create these. All disk resources that you want NetBackup to use must be configured in Veritas Enterprise Administrator (VEA) before you install NetBackup. Verify that you have an IP address and host name (virtual name) to be assigned to the NetBackup resource in VCS. Only use these for the NetBackup cluster group.The virtual name cannot be more than 15 characters. Also, verify that the disk resource is online on the node from which the NetBackup installation is about to be performed for the first time on the cluster. For a clustered NetBackup master server, if the master server is the robotic control host, physically connect the robotic devices and tape devices to each 35 NetBackup in a Veritas Cluster Server on Windows Installation prerequisites for NetBackup on VCS on Windows
Image of page 35
node where you want to install NetBackup. Connect devices by SCSI or Fibre Channel. Use OS commands to verify that all the devices are connected properly. Refer to the NetBackup Device Configuration Guide . Verify that you have the current NetBackup Enterprise Server version or the current NetBackup server version installation program and a valid license key. On Windows, the public network names must be same on both nodes of the cluster for push-installs. You should install NetBackup on the same path on all nodes. Installing a NetBackup failover server on VCS on Windows This section describes how to install and configure a new NetBackup Enterprise Server as a failover application in a VCS for Windows cluster. If you want to upgrade NetBackup, rather than complete an initial installation, you must follow a different procedure. See “Upgrading a NetBackup failover server on VCS on Windows” on page 38. Review the following notes before you begin installation: These instructions assume that this installation is a new installation of a NetBackup failover server. You must install the same type of NetBackup server on each node to which NetBackup may failover. You cannot have a separate failover master server and a separate failover media server in your NetBackup configuration.
Image of page 36
Image of page 37

You've reached the end of your free preview.

Want to read all 77 pages?

  • Winter '13
  • RobertS
  • Veritas NetBackup, cluster computing, NetBackup

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture