The host pcs will receive ip addresses over dhcp and

This preview shows page 158 - 159 out of 206 pages.

The host PCs will receive IP addresses over DHCP. and follow the guidelines below: Configure Site 1 with the following: Configure the router host name: Site-1 Prevent the router from attempting to resolve command line entries to IP addresses. Protect privileged EXEC mode from unauthorized access with the MD5 encrypted password. Prevent device status messages from interrupting command line entries at the device console. Secure the router console and terminal lines. Prevent all passwords from being viewed in clear text in the device configuration file. Configure a message-of-the-day banner. Step 2: Configure Site 1 Step 3: Configure the Router Physical Interfaces IP addresses as shown in the addressing table. Describe the operational Site 1 serial interface. The Site 1 Ethernet interfaces will be configured at the end of this assessment. DCE settings where appropriate. Use a rate of 128000 . Configure the interfaces of the routers for full connectivity with the following: Step 4: Configure static and default routing Configure the following static routes: a. Manually configure default routes to the Internet. Use the exit interface argument. All hosts on the internal LANs and Branch Network networks should be able to reach the Internet. b. It has been decided to use static routes to reach the branch networks that are connected to Site 2. Use a single summary to represent the branch networks in the most efficient way possible. Configure the summary static route on HQ and Site 2 using the exit interface argument. Step 6: Customize single-area OSPFv2 Customize single-area OSPFv2 by performing the following configuration tasks: a. Set the bandwidth of the serial interfaces to 128 kb/s . Site 1: 1.1.1.1 HQ: 2.2.2.2 Site 2: 3.3.3.3 b. Configure OSPF router IDs as follows: c. Configure the OSPF cost of the link between Site 1 and HQ to 7500 . d. Prevent routing updates from being sent out of any of the LAN interfaces that are routed with OSPFv2. Do not use the defau lt keyword in the commands you use to do this. Step 7: Configure VLANs and Trunking Configure Site1-SW1 and Site1-SW2 with VLANs and trunk ports as follows: a. Configure names for the VLANs. The VLAN names must be configured to match the names in the VLAN Table exactly (case and spelling). Refer to the VLAN table above for the VLAN numbers and names that should be configured on both switches. b. Configure the ports that link the switches with each other and the Site 1 router as functioning trunk ports. c. Assign the switch ports shown in the table as access ports in the VLANs as indicated in the VLAN Table. d. Address VLAN 101 on the network indicated in the VLAN Table. Note that the first address in this network will be assignedto the router in a later step in this assessment. The management interfaces of both switches should configured to be reachable by hosts onother networks.

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture