Step 2 create an ssh user and reconfigure the vty

This preview shows page 2 out of 2 pages.

Step 2: Create an SSH user and reconfigure the VTY lines for SSH-only access.g.Create anadministratoruser withciscoas the secret password.S1(config)#username administrator secret ciscoh.Configure the VTY lines to check the local username database for login credentials and to only allow SSHfor remote access. Remove the existing vty line password.S1(config)#line vty 0 15S1(config-line)#login localS1(config-line)#transport input sshS1(config-line)#no password ciscoPart 3: Verify SSH Implementationi.Exit the Telnet session and attempt to log back in using Telnet. The attempt should fail.j.Attempt to log in using SSH. Typesshand pressEnterwithout any parameters to reveal the commandusage instructions. Hint: The-loption is the letter “L”, not the number 1.k.Upon successful login, enter privileged EXEC mode and save the configuration. If you were unable tosuccessfully accessS1, toggle the power and begin again at Part 1.© 2018 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.Page2of2
End of preview. Want to read all 2 pages?

Upload your study docs or become a

Course Hero member to access this document

Term
Fall
Professor
Susan Cease
Tags
Cryptography, IP address, Secure Shell, Telnet

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture